液壓搖臂鉆立柱夾不緊故障及排除
原因分析：彈簧3上的螺釘調的太多，使立柱抬得太多，菱形塊夾緊機構不能是內外立柱結合的錐面壓緊；調整螺母6調的不適當，使杠桿13與殼體之間產生間隙；液壓系統中的壓力油太小，不能推動油缸立的活塞，是菱形塊不能處于夾緊的位置。
排除方法：重新調整彈簧板上的螺釘，但要保證搖臂松開時的作用力，再調整柱頂上的螺母使其夾緊力達到1568n（在搖臂末端的推力）再用螺釘鎖緊螺母；如果立柱松開時較輕，要調整螺母6，減少杠桿與殼體間的間隙，再將其上面的螺母7中的4個螺釘緊固；調整液壓系統中的壓力油保證在245-291x10000pa或更換油池中的機油。
備注：螺釘、螺母見使用說明書標注
文章引用：
搖臂夾緊調整
主軸箱夾緊
hydraulic rocker drilling column clamp tight and troubleshooting
cause analysis: spring 3 screws on the tune too much, so that the upright post too much, rhombic block clamping mechanism cannot be inside and outside column with conical compression; adjusting nut 6 adjustable inappropriate, so that the lever 13 and the shell creates a gap between; hydraulic system in the oil pressure is too small, cannot push oil cylinder set the piston is rhombic block, not in the clamping position.
elimination: reset spring board by screws, but to ensure that the rocker arm during a release of the force, and then adjust the column on the nut so that the clamping force to reach 1568n （ in the arm end thrust ） and then screw locknut; if the column is released is light, to adjusting nut 6, reduce the gap between the lever and the housing, then the nut 7 of 4 screws; adjusting hydraulic system of pressure oil assurance in 245-291x10000pa or replace the oil in the oil tank.
note: screws, nuts see manual annotation